|
Note: Shrug is worked from cuff to cuff. It consists of two rectangular pieces, stiched together at neck band: no shaping required.
Body: CO 26(29) sts. Beginning with a RS row, k 2 rows, then continue in St st until work measures 58(61)Ó from beginning (CO row), ending with a RS row. K 2 rows, BO.
Seaming: Fold the piece in half lengthwise and seam the side edges together starting at the cuff and seaming for 20(21)Ó or desired sleeve length. Repeat at the other end to form the second sleeve.
Note: There will be about 20(21)Ó of shrug left ÒopenÓ in the middle between the two sleeves. This opening will accommodate the collar.
Collar: With larger needles CO 12 (16) sts. Working in Garter st (knit every row) work for 130 (136) rows 65 (68) ridges). Piece should measure 50(52)Ó. BO. Being careful not to twist, sew BO edge to CO edge, forming a ring.
Finishing: Collar may be joined to body either by sewing with a tapestry needle or crocheted together as follows. Place seam in collar at center of raw edge opening on shrug (what will be center lower back, right sides together.Ease the side edge of ring evenly around the opening between the two sleeves. Opening is approximately 40(42)Ó, ring is approximately 50(52)Ó so there is enough ease to make the collar flare and fit properly. Seam using your preferred method. When you wear this shrug place seam in garter st. ring down center back so the collar has no seam showing when it is rolled back.
End 0406
| |